Panasonic minas a4 series Instruction Manual page 82

How to Use the Front Panel and Console
Copying of Parameters from the Console to the Driver
Operation at SELECTION display
Starting from initial LED status,
Press five time after pressing
to make a display to
Operation at EXECUTION display
Press to call for
EXECUTION DISPLAY of
Keep pressing
the console display (LED)
changes to
Reading of EEPROM of the
console starts.
Copying of parameters from
the console to the driver starts.
Writing of parameters into
the driver EEPROM starts.
After copying finishes, return to SELECTION display, referring to structure of each mode (P.60 and 61).
<Remarks>
Don't disconnect the console from the driver between
Should the connector is pulled out, insert it again and repeat the procedures from the beginning.
<Note>
If the error display repeats frequently, check the broken cable, disconnection of the connector,
misoperation due to noise or failure of console.
80
, then press
until
......Numeral decreases
as time passes.
Copying completes normally.
" " increases by
pressing (approx. 3sec)
as the left fig. shows.
<Remarks>
If error is displayed, repeat the
procedures from the beginning.
Press
to
Error display
for releasing error.