Panasonic minas a4 series Instruction Manual page 64

How to Use the Front Panel and Console
How to Set
<Remarks>
• will be displayed when you change the parameter setup which change will be validated only
after the reset. Turn off the power of the driver, then reset it.
• When writing error occurs, repeat the writing. If the writing error persists, the console might be a failure.
• Do not shut down the power during EEPROM writing, otherwise wrong data might be written.
In such case, set up all parameters again to write them again after full confirmation.
• Do not disconnect the console connector from the driver between
is disconnected, insert the connector and repeat the procedure from the beginning.
62
1) Insert the console connector to
CN X6 of the driver, and turn on
the power of the driver.
Parameter setup
2) Press .
3) Press .
4) Select the required parameters
with and .
5) Press .
6) Change the value with
and .
7) Press .
EEPROM writing
8) Press .
9) Press .
10) Keep pressing
sec), then the bars increases as
the right Fig. shows.
Writing starts.
(displays for only a moment)
Writing finishes
After the writing completes, return to SELECTION display by referring to
"Structure of each mode" (P.60 and 61).
,
(for approx.5
Writing completes
and
Writing error occurs.
. If the connector