Copyright © 2017, Juniper Networks, Inc.
To remove an AC power supply (see
Switch off the dedicated customer site circuit breaker for the power supply, and
1.
remove the power cord from the AC power source. Follow the instructions for your
site.
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
2.
ESD points on the chassis.
Swing the power cord retention clip out of the way of the power cord.
3.
Remove the power cord from the power supply.
4.
Press the release latch on the right side of the power supply to disconnect the power
5.
supply from the chassis.
Pull the power supply straight out of the chassis.
6.
Figure 52: Removing an AC Power Cord
Chapter 23: Replacing Power System Components
Figure 53 on page
172):
171