Installing An Mx104 Transceiver; Figure 50: Removing Transceivers - Juniper MX104 Hardware Manual

Installing an MX104 Transceiver

Copyright © 2017, Juniper Networks, Inc.

Figure 50: Removing Transceivers

Place a rubber safety cap over the transceiver.
8.
Place the removed transceiver on an antistatic mat or in an electrostatic bag.
9.
CAUTION: After removing a transceiver from the chassis, wait at least 30
seconds before reinserting it or inserting a transceiver into a different slot.
To install a transceiver:
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Take each transceiver to be installed out of its electrostatic bag, and identify the slot
2.
on the component where it will be installed.
Verify that each transceiver is covered by a rubber safety cap. If it is not, cover the
3.
transceiver with a safety cap.
Carefully align the transceiver with the slots in the component. The connectors should
4.
face the component.
Slide the transceiver until the connector is seated in the component slot. If you are
5.
unable to fully insert the transceiver, make sure the connector is facing the right way.
Close the ejector handle of the transceiver.
6.
Chapter 22: Replacing Line Card Components
167