Installing An Mx104 Dc Power Supply; Figure 54: Installing An Ac Power Supply - Juniper MX104 Hardware Manual

Related
Documentation

Installing an MX104 DC Power Supply

Copyright © 2017, Juniper Networks, Inc.

Figure 54: Installing an AC Power Supply

Connecting AC Power Cords to the MX104 Router on page 115
MX104 AC Power Specifications on page 95
MX104 AC Power Cord Specifications on page 96
WARNING: Before performing DC power procedures, ensure that power is
removed from the DC circuit. To ensure that all power is off, locate the circuit
breaker on the panel board that services the DC circuit, switch the circuit
breaker to the off position, and tape the switch handle of the circuit breaker
in the off position.
To install a DC power supply in the router, you need the following tools:
Phillips (+) screwdriver, number 2
ESD grounding wrist strap
Grounding ring lug with hole sized for an M5 screw
M5 nut and washer (one per DC power supply, attached)
DC power source cables, minimum 14 AWG or as required by local code (not provided)
DC power ring lugs, Panduit PV12-14HDRB-2k
M6 screws and washers (two per DC power supply, attached)
Grounding cable, minimum 14 AWG or as required by local code (not provided)
Chapter 23: Replacing Power System Components
173