Mx104 Routing Engine Ethernet Port Specifications; Cable Specifications; Pinouts; Table 56: Mx104 Routing Engine Ethernet Port Cable Specifications - Juniper MX104 Hardware Manual

MX104 3D Universal Edge Router Hardware Guide
Related
Documentation

MX104 Routing Engine Ethernet Port Specifications

Cable Specifications

Pinouts

84
Timing output when configured as BC
Connecting the MX104 Router to External Clocking and Timing Devices on page 123
MX104 BITS Port Specifications on page 89
MX104 1-PPS and 10-MHz GPS Port Specifications on page 90
MX104 Time of Day Port Specifications on page 90
Cable Specifications on page 84
Pinouts on page 84
Table 56 on page 84 lists the specifications for the cables that connect to the
port.

Table 56: MX104 Routing Engine Ethernet Port Cable Specifications

Specification
Cable specification
Cable/wire supplied
Maximum length
Router receptacle
The port on the front panel labeled
Ethernet RJ-45 receptacle that accepts an Ethernet cable for connecting the Routing
Engine to a management LAN (or other device that supports out-of-band management).
Table 57 on page 84 describes the RJ-45 connector pinout.

Table 57: Ethernet Port Pinouts

Pin Signal
1 TX+_D1
2 TX–_D1
3 RX+_D2
4 BI+_D3
Value
Category 5 cable or equivalent suitable for 1000Base-T
operation
One 15-ft (4.57-m) length with RJ-45/RJ-45 connectors
328 ft (100 m)
RJ-45 autosensing
ETHERNET is an autosensing 10/100/1000-Mbps
Description
Transmit data+
Transmit data–
Receive data+
Bidirectional+
Copyright © 2017, Juniper Networks, Inc.
ETHERNET