Installing An Mx104 Transceiver - Juniper MX104 Hardware Manual

Installing an MX104 Transceiver

Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
To install a transceiver:
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Take each transceiver to be installed out of its electrostatic bag, and identify the slot
2.
on the component where it will be installed.
Verify that each transceiver is covered by a rubber safety cap. If it is not, cover the
3.
transceiver with a safety cap.
Carefully align the transceiver with the slots in the component. The connectors should
4.
face the component.
Slide the transceiver until the connector is seated in the component slot. If you are
5.
unable to fully insert the transceiver, make sure the connector is facing the right way.
Close the ejector handle of the transceiver.
6.
Remove the rubber safety cap from the transceiver and the end of the cable. Insert
7.
the cable into the transceiver.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
Verify that the status LEDs on the front panel indicate that the transceiver is functioning
8.
correctly. For more information about the component LEDs, see the
Overview" on page 11.
MX104 Chassis Overview on page 4
MX104 Modular Interface Card (MIC) Overview on page 47
Maintaining the MX104 MICs and Network Ports on page 192
Removing an MX104 Transceiver on page 166
Chapter 22: Replacing Line Card Components
"MX104 LEDs
165