Installation Safety Guidelines And Warnings; Installation Safety Warnings For Juniper Networks Devices; Intrabuilding Ports Warning; Installation Instructions Warning - Juniper MX104 Hardware Manual

CHAPTER 32
Installation Safety Guidelines and
Warnings

Installation Safety Warnings for Juniper Networks Devices

Intrabuilding Ports Warning

Installation Instructions Warning

Copyright © 2017, Juniper Networks, Inc.
Installation Safety Warnings for Juniper Networks Devices on page 225
Observe the following warnings before and during hardware equipment installation:
Intrabuilding Ports Warning on page 225
Installation Instructions Warning on page 225
Rack-Mounting Requirements and Warnings on page 226
Ramp Warning on page 230
WARNING: The intrabuilding ports of the equipment or subassembly are
suitable for connection to intrabuilding or unexposed wiring or cabling only.
The intrabuilding ports of the equipment or subassembly MUST NOT be
metallically connected to interfaces that connect to the Outside Plant (OSP)
or its wiring. These interfaces are designed for use as intrabuilding interfaces
only (Type 2 or Type 4 ports as described in GR-1089) and require isolation
from the exposed OSP cabling. The addition of Primary Protectors is not
sufficient protection in order to connect these interfaces metallically to OSP
wiring.
WARNING: Read the installation instructions before you connect the hardware
equipment to a power source.
Waarschuwing Raadpleeg de installatie-aanwijzingen voordat u het systeem
met de voeding verbindt.
Varoitus Lue asennusohjeet ennen järjestelmän yhdistämistä virtalähteeseen.
225