MX104 3D Universal Edge Router Hardware Guide
Installing an MX104 AC Power Supply
172
Figure 53: Removing an AC Power Supply
To install an AC power supply (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Using both hands, slide the power supply straight into the chassis until the power
2.
supply is fully seated in the chassis slot. The power supply faceplate should be flush
with any adjacent power supply faceplate or blank installed in the power supply slot.
Attach the power cord to the power supply.
3.
Secure the power cord with the power cord retainer clip.
4.
Attach the power cord to the AC power source, and switch on the dedicated customer
5.
site circuit breaker. Follow the instructions for your site.
Observe the status LED on the power supply faceplate. If the power supply is correctly
installed and functioning normally, the status LED lights green steadily.
Figure 51 on page
170):
Copyright © 2017, Juniper Networks, Inc.