Connecting The Mx104 Router To Power; Connecting The Mx104 Router To Earth Ground - Juniper MX104 Hardware Manual

CHAPTER 15

Connecting the MX104 Router to Power

Connecting the MX104 Router to Earth Ground

Copyright © 2017, Juniper Networks, Inc.
Connecting the MX104 Router to Earth Ground on page 113
Connecting AC Power Cords to the MX104 Router on page 115
Connecting DC Power Cables to the MX104 Router on page 117
To ground the router, you need the following tools:
Phillips (+) screwdriver, number 2
ESD grounding wrist strap
Two SAE 10-32 screws and flat washers
Grounding lug, Panduit LCD10-10-L
Grounding cable that meets the following specifications:
For AC systems—Use a 14-AWG (2.08 mm
For 24 V systems—Use 6-AWG (13.3 mm
You ground the router by connecting a grounding cable to earth ground and then attaching
it to the chassis grounding points on the front of the router. To ground the router:
Verify that a licensed electrician has attached the cable lug provided with the router
1.
to the grounding cable.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to an approved site ESD grounding point. See the instructions for your site.
Ensure that all grounding surfaces are clean and brought to a bright finish before
3.
grounding connections are made.
Connect the grounding cable to a proper earth ground.
4.
Detach the ESD grounding strap from the site ESD grounding point.
5.
2 °
) 90 C wire
2 °
) 60 C wire (not provided)
113