Replacing Power System Components; Installing An Mx104 Ac Power Supply - Juniper MX104 Hardware Manual

CHAPTER 23

Replacing Power System Components

Installing an MX104 AC Power Supply

Copyright © 2017, Juniper Networks, Inc.
Installing an MX104 AC Power Supply on page 169
Replacing an MX104 AC Power Supply on page 170
Installing an MX104 DC Power Supply on page 173
Replacing an MX104 DC Power Supply on page 177
To install an AC power supply (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Using both hands, slide the power supply straight into the chassis until the power
2.
supply is fully seated in the chassis slot. The power supply faceplate should be flush
with any adjacent power supply faceplate or blank installed in the power supply slot.
Attach the power cord to the power supply.
3.
Secure the power cord with the power cord retainer clip.
4.
Attach the power cord to the AC power source, and switch on the dedicated customer
5.
site circuit breaker. Follow the instructions for your site.
Observe the status LED on the power supply faceplate. If the power supply is correctly
installed and functioning normally, the status LED lights green steadily.
Figure 51 on page 170):
169