Figure 58: Disconnecting The Dc Power Cables - Juniper MX104 Hardware Manual

MX104 3D Universal Edge Router Hardware Guide
178
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
4.
ESD points on the chassis.
Remove the clear plastic cover protecting the terminal studs on the faceplate (see
5.
Figure 58 on page 178).
Remove the screw and washer from each of the terminals. (Use a number 2 Phillips
6.
screwdriver.)
Remove the cable lugs from the terminals.
7.
Carefully move the power cables out of the way.
8.
Remove the nut and washer from the DC power supply grounding point (see
9.
Figure 59 on page 179).
Remove the cable lug from the grounding point.
10.
Move the grounding cable out of the way.
11.
Press the release latch on the right side of the power supply to disconnect the power
12.
supply from the chassis.
Grasp the handle on the power supply and pull the power supply straight out of the
13.
chassis.

Figure 58: Disconnecting the DC Power Cables

Copyright © 2017, Juniper Networks, Inc.