Commands In The Global Configuration Mode; Mac Access-List Extended - Siemens SCALANCE XM-400 Configuration Manual

Result
The access control list of the selected IP interface is displayed.
11.3.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
11.3.2.1

mac access-list extended

Description
With this command, you generate a MAC access control list and change to the MAC ACL
configuration mode.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
mac access-list extended<access-list-number(1-128)>
The parameter has the following meaning:
Parameter
access-list-number
Result
A MAC access control list has been generated.
You are now in the MAC ACL configuration mode.
The command prompt is as follows:
cli(config-ext-macl)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
configure terminal
Description
Number of the access control list
Security and authentication
11.3 MAC access control list
command to change to this mode.
or command and are then in the
end exit
Range of values / note
1 ... 128
699