No Redist-Config - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.2 OSPFv2 (IPv4)
Further notes
You remove the information with the
You distribute the routes with the
9.2.3.20

no redist-config

Description
With this command, you delete the information for the new external routes.
Note
This command is available only with layer 3.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
no redist-config <Network> <Mask>
The parameters have the following meaning:
Parameter
Network
Mask
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The information for the route is deleted.
Further notes
You create the information with the
474
no redist-config
command.
restribute
Description
Target address of the route.
Subnet mask of this route
redist-config
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
command.
Range of values / note
specify the IP address.
specify the subnet mask.
command.
Configuration Manual, 11/2015, C79000-G8976-C252-10