Ntp Client; The "Show" Commands; Show Ntp Info - Siemens SCALANCE XM-400 Configuration Manual

Syntax
Call up the command with the following parameters:
no time dst [<name(16>]
The parameter has the following meaning:
Parameter
name
Result
An entry or the entries for the start and end of daylight saving time was/were deleted.
5.2

NTP Client

This section describes commands relevant for configuration of the NTP client.
5.2.1

The "show" commands

This section describes commands with which you display various settings.
5.2.1.1

show ntp info

Description
This command shows the current settings for the Network Time Protocol (NTP).
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show ntp info
Result
The current NTP settings are displayed.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
Description
Name of the entry
or
cli#
System time
5.2 NTP Client
Range of values / note
maximum 16 characters
151