9.2.3.19
redist-config
Description
With this command, you configure the information for the route. The routes are further
distributed with this information.
Note
This command is available only with layer 3.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
redist-config <Network> <Mask>
[metric-value <metric (1 - 16777215)>]
[metrictype {
asExttype1 | asExttype2
}]
The parameters have the following meaning:
Parameter
Network
Mask
metric-value
metric
metrictype
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The information for the route is specified.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
Description
Target address of the route.
Subnet mask of this route
Keyword for the metric of the route
Metric
Keyword for the connection costs
Layer 3 functions
9.2 OSPFv2 (IPv4)
Range of values / note
enter the IPv4 address.
specify the subnet mask.
-
1 - 16777215
•
asExttype1
External and internal costs
•
asExttype2
External costs
473