Router Ospf - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.2 OSPFv2 (IPv4)
9.2.2.1

router ospf

Description
With this command, you enable routing with OSPF and change to the OSPF Router
configuration mode.
Note
This command is available only with layer 3.
Requirement
● IPv4 routing is activated
● You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
router ospf
Result
Routing with OSPF is enabled.
You are now in the OSPF Router configuration mode.
The command prompt is as follows:
cli (config-ospf)#
Further notes
You disable routing with OSPF with the
You enable IPv4 routing with the
450
command.
no router ospf
command.
ip routing
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10