Ip Ospf Authentication-Key - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.2 OSPFv2 (IPv4)
Result
The type of authentication is reset.
Further notes
You enable the authentication with the
9.2.4.3

ip ospf authentication-key

Description
With this command, you specify the password.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
ip ospf authentication-key <password (8)>
The parameter has the following meaning:
Parameter
Password
Result
The password is specified.
Further notes
You delete the password with the
484
ip ospf authentication
Description
Password
no ip ospf authentication-key
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
command.
Range of values / note
Enter a password.
Maximum length: 8 characters
command.
Configuration Manual, 11/2015, C79000-G8976-C252-10