Show Dot1X Mac-Auth Mac-Info; Commands In The Global Configuration Mode; Dot1X Guest-Vlan - Siemens SCALANCE XM-400 Configuration Manual

Result
A list with guest VLAN, MAC address and port is displayed.
11.7.1.3

show dot1x mac-auth mac-info

Description
This command shows the MAC addresses for which MAC authentication is enabled.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show dot1x mac-auth mac-info
Result
A list of the MAC addresses is displayed.
11.7.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
11.7.2.1

dot1x guest-vlan

Description
With this command, you enable the guest VLAN function for the device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
or
cli#
11.7 Port Based Network Access Control
command to change to this mode.
configure terminal
or
end exit
Security and authentication
command and are then in the
743