Whoami; Commands In The Global Configuration Mode; Role - Siemens SCALANCE XM-400 Configuration Manual

11.1.3

whoami

Description
This command shows the user name of the logged in user.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
whoami
Result
The user name of the logged in user is displayed.
11.1.4

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
11.1.4.1

role

Description
With this command, you create roles that are valid locally on the device.
Note
You can create up to 28 additional roles.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
or
cli#
command to change to this mode.
configure terminal
or
end exit
Security and authentication
11.1 User management
command and are then in the
679