No Dcp Server; Ip Domain Lookup - Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.1 IPv4 protocol
Result
The read and write permissions for the DPC server are configured.
The DCP server is enabled.
Further notes
You disable the DCP server with the
7.1.2.10

no dcp server

Description
With this command, you disable the DCP server.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no dcp server
Result
The DCP server is disabled.
Further notes
You enable and configure the DCP server with the
7.1.2.11

ip domain lookup

Description
This command enables the DNS client of the device. To be able to use the function, a DNS
server must be reachable.
272
command.
no dcp server
dcp server
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
command.