Show Forward-Unregistered; Commands In The Global Configuration Mode; Gmrp - Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.1 GARP
8.1.1.2

show forward-unregistered

Description
With this command, you display the entries of the GMRP forward unregistered table.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show forward-unregistered
Result
The entries of the GMRP forward unregistered table are displayed.
8.1.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
8.1.2.1

gmrp

Description
With this command, you enable the GMRP function for all or individual interfaces on the
device.
Requirement
You are in the Global configuration mode
or
You are in the Interface configuration mode
The command prompt is as follows:
cli(config)#
cli (config-if-$$$) #
388
or
cli#
command to change to this mode.
configure terminal
or
end exit
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
command and are then in the