Show Subnet-Vlan Mapping - Siemens SCALANCE XM-400 Configuration Manual

Syntax
Call up the command with the following parameters:
show mac-address-table count[vlan<vlan-id(1-4094)>]
The parameters have the following meaning:
Parameter
vlan
vlan-id
If you do not select any parameter from the parameter list, the total number of entries is
displayed for all VLANs.
Result
The number of MAC addresses for the selected VLAN is displayed.
6.1.1.7

show subnet-vlan mapping

Description
This command shows the entries of a subnet VLAN table.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show subnet-vlan mapping
The parameters have the following meaning:
Parameter
interface
interface-type
interface-id
switch
string
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you do not select any parameter from the parameter list, all entries are displayed.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
Description
Keyword for a VLAN connection
Number of the addressed VLAN
or
cli#
[{interface<interface-type><interface-id>|switch<string(32)>}]
Description
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
Keyword for a switch
Name of the switch
Network structures
6.1 VLAN
Range of values / note
-
1 ... 4094
Range of values / note
-
Enter a valid interface.
-
max. 32 characters
173