Configure Dhcpv6 Mode On The Routing Interface; Cli: Configure Dhcpv6 Mode On Routing Interface - NETGEAR M4200 Software Administration Manual

e. Click Apply.
6. Assign an IPv6 address to the routing VLAN.
a. Select Routing > IPv6 > Advanced > Prefix Configuration.
A screen similar to the following displays.
b. In the Interface field, select 0/4/2.
c. In the IPv6 Prefix field, enter 2000::1.
d. In the Length field, enter 64.
e. In the EUI64 field, select Disable.
f. Click Add.

Configure DHCPv6 Mode on the Routing Interface

The routing interface supports DHCPv6 mode, which can get the IPv6 address from a
DHCPv6 server (address allocation).
Note: Before you enable DHCPv6 mode, you must disable IPv6 unicast
mode globally.

CLI: Configure DHCPv6 mode on routing interface

1. Enable IPv6 unicast globally.
(Netgear Switch) (Config)#ipv6 unicast-routing
Managed Switches
IPv6 Interface Configuration
551