Cli: Configure Area 1 As A Stub Area On A2 - NETGEAR M4200 Software Administration Manual

CLI: Configure Area 1 as a Stub Area on A2

1. Enable routing on the switch.
(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing
(Netgear Switch) (Config)#router ospf
2. Set the router ID to 2.2.2.2.
(Netgear Switch) (Config-router)#router-id 2.2.2.2
3. Configure area 0.0.0.1 as a stub area.
(Netgear Switch) (Config-router)#area 0.0.0.1 stub
4. Enable OSPF area 0.0.0.1 on the 1/0/15.
(Netgear Switch) (Config-router)#exit
(Netgear Switch) (Config-router)#exit
(Netgear Switch) (Config)#interface 1/0/15
(Netgear Switch) (Interface 1/0/15)#routing
(Netgear Switch) (Interface 1/0/15)#ip address 192.168.20.2
(Netgear Switch) (Interface 1/0/15)#ip ospf
(Netgear Switch) (Interface 1/0/15)#ip ospf areaid 0.0.0.1
(Netgear Switch) (Interface 1/0/15)#exit
(Netgear Switch) (Config)#exit
(Netgear Switch) #show ip route
Total Number of Routes......................... 2
Network Subnet
Address
--------------- --------------- ------------
0.0.0.0 0.0.0.0
192.168.20.0 255.255.255.0
Managed Switches
Mask Protocol
OSPF Inter
Local
OSPF
120
255.255.255.0
Next Hop Next Hop
Intf IP Address
--------- ---------------
1/0/15 192.168.20.1
1/0/15 192.168.20.2