Enable Routing For The Switch; Cli: Enable Routing For The Switch; Web Interface: Enable Routing For The Switch - NETGEAR M4200 Software Administration Manual

Enable Routing for the Switch

The example is shown as CLI commands and as a web interface procedure.

CLI: Enable Routing for the Switch

(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing
(Netgear Switch) (Config)#exit

Web Interface: Enable Routing for the Switch

1. Select Routing > IP > Basic > IP Configuration.
A screen similar to the following displays.
2. For Routing Mode, select the Enable radio button.
3. Click Apply to save the settings.
Managed Switches
RIP
90