Vrrp On A Backup Router; Cli: Configure Vrrp On A Backup Router - NETGEAR M4200 Software Administration Manual

A screen similar to the following displays.
b. Under Global Configuration, next to the Admin Mode, select Enable radio button.
c. Enter the following information in the VRRP Configuration:
• In the VRID (1 to 255) field, enter 20.
• In the Interface field, select 1/0/2.
• In the Primary IP Address field, enter 192.150.2.1.
• In the Mode field, select Active.
d. Click Apply to save the settings.

VRRP on a Backup Router

The example is shown as CLI commands and as a web interface procedure.

CLI: Configure VRRP on a Backup Router

1. Enable routing for the switch. IP forwarding will then be enabled by default.
(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing
2. Configure the IP addresses and subnet masks for the port that will participate in the protocol.
(Netgear Switch) (Config)#interface 1/0/4
(Netgear Switch) (Interface 1/0/4)#routing
(Netgear Switch) (Interface 1/0/4)#ip address 192.150.4.1 255.255.0.0
(Netgear Switch) (Interface 1/0/4)#exit
3. Enable VRRP for the switch.
(Netgear Switch) (Config)#ip vrrp
Managed Switches
VRRP
159