Source Switch - NETGEAR M4200 Software Administration Manual

(Netgear Switch) #vlan database
(Netgear Switch) (Vlan)#vlan 5
(Netgear Switch) (Vlan)#exit
(Netgear Switch) #config
(Netgear Switch) (Config)#vlan 5
(Netgear Switch) (Config)(Vlan 5)#remote-span
(Netgear Switch) (Config)(Vlan 5)#exit
(Netgear Switch) (Config)#monitor session 1 mode
(Netgear Switch) (Config)#monitor session 1 source interface 1/0/1
(Netgear Switch) (Config)#monitor session 1 destination remote vlan 5 reflector-port
1/0/2
(Netgear Switch) (Config)#exit
(Netgear Switch) #show monitor session 1
Session Admin Probe
ID Mode Port
------- ------- ------ ---- -------- ------ ----- ----- ----- ------- -------
1 Enable
2. On the intermediate switches (Switch 2 and Switch 3), configure the ports that are
connected to the source and destination switches as tagged members of the VLAN.
Note: You do not need to configure RSPAN on the intermediate switches.
(Netgear Switch) #vlan database
(Netgear Switch) (Vlan)#vlan 5
(Netgear Switch) (Vlan)#exit
(Netgear Switch) #config
(Netgear Switch) (Config)#interface 1/0/23
(Netgear Switch) (Interface 1/0/23)#vlan participation include 5
(Netgear Switch) (Interface 1/0/23)#vlan tagging 5
(Netgear Switch) (Interface 1/0/23)#exit
(Netgear Switch) (Config)#interface 1/0/24
(Netgear Switch) (Interface 1/0/24)#vlan participation include 5
(Netgear Switch) (Interface 1/0/24)#vlan tagging 5
(Netgear Switch) (Interface 1/0/24)#exit
3. On the destination switch (Switch 4), configure the following settings:
• RSPAN VLAN (the source of the mirrored traffic)
• The probe port (the port that is connected, through the intermediate switches, to the

source switch)

Managed Switches
Src Mirrored Ref.
VLAN Port Port
1/0/1 1/0/2
Tools
409
Src Dst Type IP
RVLAN RVLAN ACL
5 Rx,Tx
MAC
ACL