Cli: Create A Link State Group; Web Interface: Create A Link State Group - NETGEAR M4200 Software Administration Manual

CLI: Create a Link State Group

1. Create a link state group with group number 1.
(Netgear Switch) (Config)#link state group 1 action down
2. Configure port 1/0/1 as an upstream link.
(Netgear Switch) (Config)#interface 1/0/1
(Netgear Switch) (Interface 1/0/1)#link state group 1 upstream
3. Configure port 1/0/5 as a downstream link.
(Netgear Switch) (Interface 1/0/1)#interface 1/0/5
(Netgear Switch) (Interface 1/0/5)#link state group 1 downstream
(Netgear Switch) (Interface 1/0/5)#exit
4. Display the status of the link state group with group number 1.
(Netgear Switch) #show link state group 1
GroupId Downstream Interfaces
------- ----------------------
1 1/0/5

Web Interface: Create a Link State Group

1. Configure the action for link state group with group number 1.
a. Select System > Link Dependency > Link Dependency Group Configuration.
A screen similar to the following displays.
Managed Switches
Upstream Interfaces
--------------------
1/0/1
Link Dependency
660
Link Action Group State
------------ -----------
Link Down Up