Connect with NETGEAR SFP AGM731F
Cisco provides a way to support third-party small form-factor pluggables (SFPs). For
example, you can get the NETGEAR SFP AGM731F to work between a Cisco switch and a
NETGEAR switch.
1.
Before connecting the NETGEAR switch to the Cisco switch, configure the following
command on the Cisco switch.
service unsupported-transceiver
no errdisable detect cause gbic-invalid
2.
Make sure that the autonegotiation mode is the same on both sides.
The following supported AN mode can be configured on the NETGEAR switch and the
Cisco switch.
XCM8944+AGM731F
Autonegotiate
No Autonegotiate
Managed Switches
CISCO+AGM731F
No speed nonegotiate
speed nonegotiate
NETGEAR SFP
684
Result
Link is up
Link is up