Cli: Configure The 10G Copper Ports As Stack Ports - NETGEAR M4200 Software Administration Manual

CLI: Configure the 10G Copper Ports as Stack Ports

1. On Switch A, configure the stack port and reboot the switch.
(Netgear Switch) #show stack-port
Unit Interface
---- ---------------- ---------- ---------- ------------ ------------
2 0/25
2 0/26
2 0/27
2 0/28
(Netgear Switch) #
(Netgear Switch) #config
(Netgear Switch) (Config)#stack
(Netgear Switch) (Config-stack)#stack-port 2/0/28 stack
(Netgear Switch) (Config-stack)#exit
(Netgear Switch) (Config)#exit
(Netgear Switch)#exit
(Netgear Switch) #reload
Management switch has unsaved changes.
Would you like to save them now? (y/n) y
Config file 'startup-config' created successfully.
Configuration Saved!
Are you sure you want to reload the stack? (y/n)y
2. After Switch A reboots, check the stack port configuration.
(M4300-28G-PoE+) #show stack-port
Unit Interface
---- ---------------- ---------- ---------- ------------ ------------
2 0/25
2 0/26
2 0/27
2 0/28
Managed Switches
Configured Running
Stack Stack
Mode Mode
Ethernet Ethernet
Ethernet Ethernet
Ethernet Ethernet
Ethernet Ethernet
Configured Running
Stack Stack
Mode Mode
Ethernet Ethernet
Ethernet Ethernet
Ethernet Ethernet
Stack Stack
Switch Stacks
441
Link Link
Status Speed (Gb/s)
Link Down 10
Link Down 10
Link Down 10
Link Down 10
Link Link
Status Speed (Gb/s)
Link Down 10
Link Down 10
Link Down 10
Link Down 10