Example 2: Change The Queue Of Protocol-Based Auto Voip - NETGEAR M4200 Software Administration Manual

Example 2: Change the Queue of Protocol-Based Auto VoIP

This example is provided as CLI commands and as a web interface procedure.
CLI: Change the Queue of Protocol-Based Auto VoIP
Protocol-based VoIP classifies and prioritizes packets and places them in the higher-priority
queue. By default, the packets are placed in egress queue 6. However, you can override the
egress queue setting. The following example shows how to assign the protocol-based Auto
VoIP to egress queue 4.
1. Change the egress queue of protocol-based Auto VoIP.
(Netgear Switch) (Config)#auto-voip protocol-based traffic-class 4
2. Display the Auto VoIP information.
(Netgear Switch) #show auto-voip protocol-based interface 2/0/1
VoIP VLAN Id................................... 2
Prioritization Type............................ traffic-class
Class Value.................................... 4
Interface Auto VoIP Mode Operational Status
--------- -------------- -----------------
2/0/1 Enabled
Web Interface: Configure Protocol-Based Auto VoIP
1. Change the queue of protocol-based Auto VoIP.
a. Select Switching > Auto-VoIP > Protocol-based > Port Settings.
A screen similar to the following displays.
b. From the Class Value menu, select 4.
c. Click Apply.
Managed Switches
Up
DiffServ
258