Web Interface: Show Mac-Address-Table Igmpsnooping; External Multicast Router; Cli: Configure The Switch With An External Multicast Router; Web Interface: Configure The Switch With An External Multicast Router - NETGEAR M4200 Software Administration Manual

Web Interface: Show mac-address-table igmpsnooping

Select Switching > Multicast > IGMP Snooping Table.
A screen similar to the following displays.

External Multicast Router

The example is shown as CLI commands and as a web interface procedure.

CLI: Configure the Switch with an External Multicast Router

This example configures the interface as the one the multicast router is attached to. All IGMP
packets that are snooped by the switch are forwarded to the multicast router that is reachable
from this interface.
(Netgear Switch)(Interface 1/0/3)# set igmp mrouter interface
Web Interface: Configure the Switch with an External
Multicast Router
1. Select Switching > Multicast > Multicast Router Configuration.
A screen similar to the following displays.
2. Under Multicast Router Configuration, scroll down and select the Interface 1/0/3 check box.
Now 1/0/3 appears in the Interface field at the top.
3. In the Admin Mode field, select Enable.
4. Click Apply.
Managed Switches
IGMP Snooping and Querier
282