NETGEAR M4200 Software Administration Manual page 539

Web Interface: Create a 6to4 Tunnel on Switch 3
1. Enable IP routing on Switch 3.
a. Select Routing > IP > Basic > IP Configuration.
A screen similar to the following displays.
b. For Routing Mode, select the Enable radio button.
c. Click Apply.
2. Enable IPv6 forwarding and unicast routing on Switch 3.
a. Select Routing > IPv6 > Basic> Global Configuration.
A screen similar to the following displays.
b. For IPv6 Unicast Routing, select the Enable radio button.
c. Click Apply.
3. Create a routing interface and assign an IP address to it.
a. Select Routing > IP > Advanced > IP Interface Configuration.
A screen similar to the following displays.
Managed Switches
Tunnels for IPv6
539