NETGEAR M4200 Software Administration Manual page 542

• In the EUI64 field, select Disable.
• In the Source Address field, enter 195.1.4.2.
c. Click Add.
d. Configure the following tunnel settings:
• In the Tunnel ID field, select 0.
• In the Mode field, select 6-to-4.
• In the IPv6 Mode field, select Enable.
• In the IPv6 Address/Prefix Length field, enter 2002:c301:502::1/16.
• In the EUI64 field, select Disable.
• In the Source Address field, enter 195.1.5.2.
e. Click Add.
7. Create a static route for subnet 195.1.3.0/24.
a. Select Routing > Routing Table > Advanced > Route Configuration.
A screen similar to the following displays.
b. Configure the following route settings:
• In the Network Address field, enter 195.1.3.0.
• In the Subnet Mask field, enter 255.255.255.0.
• In the Next Hop Address field, enter 195.1.5.1.
c. Click Add.
Managed Switches
Tunnels for IPv6
542