Web Interface: Show Logging Hosts; Configure Logging For A Port; Cli: Configure Logging For The Port - NETGEAR M4200 Software Administration Manual

Web Interface: Show Logging Hosts

Select Monitoring > Logs > Sys Log Configuration. A screen similar to the following
displays.

Configure Logging for a Port

The example is shown as CLI commands and as a web interface procedure.

CLI: Configure Logging for the Port

(Netgear Switch)
(Netgear Switch) (Config)#logging ?
buffered
cli-command
console
host
syslog
(Netgear Switch) (Config)#logging host ?
<hostaddress>
reconfigure
remove
(Netgear Switch) (Config)#logging host 192.168.21.253 ?
<cr>
<port>
Managed Switches
#config
Buffered (In-Memory) Logging Configuration.
CLI Command Logging Configuration.
Console Logging Configuration.
Enter IP Address for Logging Host
Syslog Configuration.
Enter Logging Host IP Address
Logging Host Reconfiguration
Logging Host Removal
Press Enter to execute the command.
Enter Port Id
Syslog
429