Configure Dhcpv6 Mode On The Routing Interface - NETGEAR ProSafe GSM5212P Software Administration Manual

Configure DHCPv6 Mode on the Routing Interface

The routing interface supports DHCPv6 mode, which can get the IPv6 address from a
DHCPv6 server (address allocation).
Note: Before you enable DHCPv6 mode, you have to disable IPv6 unitcast
mode globally.
CLI: Configure DHCPv6 mode on routing interface
1. Enable IPv6 unicast globally.
(Netgear Switch) (Config)#ipv6 unicast-routing
2. Enable DHCPv6 on the interface 1/0/23.
(Netgear Switch) (Config)#interface 1/0/23
(Netgear Switch) (Interface 1/0/23)#routing
(Netgear Switch) (Interface 1/0/23)#ipv6 enable
(Netgear Switch) (Interface 1/0/23)#ipv6 address dhcp
(Netgear Switch) (Interface 1/0/23)
400 | Chapter 27. IPv6 Interface Configuration
ProSafe Managed Switch