Table of Contents
Advertisement
Engine Maintenance (SP) Mode
Entering/Exiting SP Mode
To enter SP Mode
1.
Enter the Service Mode.
SYSTEM Ver. nnn
Service Menu
2.
[
/Menu] or [
• Engine Maint. allows changing the settings of individual SP codes
• For more about individual SP code settings, refer to the tables in this section.
• There are no settings available for the following groups: SP1-XXX, SP3-XXX, SP5-XXX,
SP7XXX, SP9XXX
To exit SP mode
1.
At any level in the SP mode, press [Escape] to return to the first level.
SYSTEM Ver. nnn
Service Menu
2.
[
/Menu] or [
The machine returns to standby mode.
-or-
If you changed a setting, the machine may switch off. Press [Power] to switch the machine on
again. This enables the new setting(s).
Using SP Mode Menus
Entering an Engine SP Code Directly
Do this procedure to enter an SP code directly if you know the number.
1.
In the service tables of this section, look up the number and name of the SP code to set.
Example: Set SP1-001-003 FDLEN:OFFSET for -2.5mm
"Adjust Amount of LF Offset in Sub Scan Direction"
Range: [-128 to +127/0/1/0.1mm]
]> "Engine Maint."> [#Enter].
]> "End"> [#Enter].
Service Mode and Engine Maintenance Mode
175
Advertisement
Table of Contents
