Controller - HP 8753E User Manual

Controller

An external controller is not required for measurement calibration or time domain capability.
However, some performance test procedures are semi-automated and require the use of an
external controller. (The system verification procedure does not require an external controller.)
The system can be automated with the following computers:
IBM PC compatible computer with an HP-IB/GP-IB interface card
HP 9000 series 200/300 workstation
n
HP 9000 series 700 workstation with HP BASIC-UX
l
For more information about compatible computers, call your nearest Hewlett-Packard Sales and
Service office.
Sample Software
A set of sample measurement programs is provided with the
used as an introductory example for progr amming the analyzer over HP-IB. It is designed to be
easily modified for use in developing programs for specific needs. The programs are compatible
with HP BASIC versions 2.0 and later, QuickBASIC, and QuickC, and will run on an IBM PC
compatible computer (as well as the HP 9000 series 200/300/700 workstations), using any
HP 87533 compatible printer or plotter.
The following additional software products are also available for the HP 8753E:
HP 85190A IC-CAP Modeling Suite
n
Touchstone
n
(MDS) HP Microwave Design System
n
n
External Monitors
The analyzer can drive both its internal display and an external monitor simultaneously.
I&commended Color Monitors:
HP D2804A, Super VGA 1024 (14 inch display)
n
HP D2806B, Ergo Ultra VGA (15 inch display)
n
HP D2817A, Ultra VGA 1280 (17 inch display)
n
VGA Compatible
640 (horizontal) x 480 (vertical) resolution
q
59.83 Hz vertical refresh rate
q
16.716 mS vertical time
q
31.41 kHz horizontal refresh rate
q
31.840 &S horizontal time
q
75 ohm video input impedance
q
video analog amplitude 0.7 Vp-p
q
negative true TI'L logic for vertical and horizontal synchronization
q
HP 8753E Network Atruzlgm
Compatible Peripherals 11-7