HP 8753E User Manual page 502

has two functions:
sequence, press the softkey next to the desired sequence title,
When entered into a sequence, this command performs a
n
one-way jump to the sequence residing in the specilled
sequence position (SEQUENCE 1 through 6). ~~~~~~~~
jumps to a softkey position, not to a specific sequence title.
Whatever sequence is in the selected softkey position will
command prompts the operator to select a destination
sequence position.
and turns error correction on.
and turns error correction on.
finishes response and isolation calibration (after all standards
are measured) and turns error correction on.
finishes response calibration (after all standards are measured)
and turns error correction on.
terminates the sequencing edit mode.
measured) and turns error correction on.
sets the analyzer's source higher than the analyzer's receiver
for making measurements in frequency offset mode.
toggles between the display of both measurement channels
or the active channel only. This is used in cor@nction with
traces are overlaid on a single graticule.
activates a sub-menu of I-d, which allows you to enable the
auxiliary channels and configure multiple-channel displays.
duplicates a sequence currently in memory into a different
Follow the prompts on the analyzer screen. This command does
not affect the original sequence.
. .
Key Definitions U-13