HP 8753E User Manual page 660

The CITINe Keyword Reference
Keyword
CITIFILE
NAME
VAR
SEG-LIST-BEGIN
SEG-LIST-END
Explanation and Examples
CITIFILE A. 01.01 identifies the Ele as a CITIflle, and indicates the
revision level of the llle. The CITIflle keyword and revision code must
precede any other keywords. The CITIlile keyword at the beginning
of the package assures the device reading the file that the data that
follows is in the CITIllle format. The revision number allows for future
extensions of the CITIflle standard. The revision code shown here
following the CITIflle keyword indicates that the machine writing this
extensions of CITIflle will increment the revision code.
NAME CAL-SET allows the current CITIllle "package" to be named. The
name of the package should be a single word with no embedded spaces.
A list of standard package names follows:
Definition
Label
RAW-DATA Uncorrected data.
DATA Data that has been error corrected. When only a
single data array exists, it should be named DATA.
FORMATTED Corrected and formatted data.
Data trace stored for comparison purposes.
MEMORY
Coefficients used for error correction.
CAL-SET
CAL-KIT Description of the standards used
DELAY-TABLE Delay coefficients for calibration.
VAR FREQ MAG 201 defines the name of the independent variable
(FREQ), the format of values in a VARLIST~BEGIN table (MAG, if
used), and the number of data points (201). Typical names for the
independent variable are FREQ (in Hz), TIME (in seconds), and POWER
(in dBm). For the VARLIST-BEGIN table, only the "MAG" format is
supported at this point.
device to be defined. The pound sign (#) tells the device reading the
file that the following variable is for a particular device. The "NA"
shown here indicates that the information is for a Network Analyzer.
This convention allows new devices to be defined without fear of
conflict with keywords for previously deilned devices The device
SEG,LIST-BEGIN indicates that a list of segments for the independent
[stop] [number of points]. The current implementation only
supports a single segment. If there is more than one segment, the
only the SEG (linear segment) segment type.
SEG,LIST-END defines the end of a list of independent variable
segments.
The ClTlfile Data Fomat and Keyword Reference