HP 8753E User Manual page 610

Error Number You can only nest sequences to a maximum level of six. The sequence will
164 abort if you nest more than six.
Error Number You can have a maximum of 30 segments or 1632 points in frequency list mode.
50 In power meter calibrations, you can have a maximum of 12 segments for
power sensor cal factors and power loss functions.
Error Number You can perform a time domain transformation only in linear and CW sweep
16 types.
Service Error Your equipment setup for the adjustment procedure in progress is not correct.
Number 115 Check the setup diagram and instructions
Information In single sweep mode, the instrument ensures that aI.l changes to the
Message instrument state, if any, have been implemented before taking the sweep. The
command that you have initiated is being processed and wiII not be complete
until the new sweep is completed. An asterisk * is displayed in the left margin
until a complete fresh sweep has been taken.
Information This message is displayed between the start and finish of a read or write
operation to a disk.
Message
HP 8753E Network Anulgm semrice