HP 8753E User Manual page 66

Note Make sure you connect the calibration standards to the Rx port of the test
adapter (or a cable attached to it) for the FORWARD calibration, and the
Antenna port for the REVERSE calibration.
12. When the calibration has been completed, save this state in the analyzer:
13. Connect the DUT to the test adapter.
14. Enable both auxiliary channels 3 and 4:
Press (Display) ~~~~~~~ ,;f@%JR~ set AI& ~:~I$&& to ON, press @GiJ and set &J@$HA# to
ON.
15. Set up a two-graticule, four-channel display:
16. Set the measurement parameters (channel 1 should be active):
This is the transmission of the 'k-to-Ant path.
This is the reflection at the TX port.
This is the transmission of the Ant-to-Rx path.
This is the reflection at the Rx port.
The display will be similar to Figure 2-7.
. . . . . . . . . . . . . . . . . . . . L .
. . . . . . : : : :
Making Measurements 2-15