The Sequencing Menu - HP 8753E User Manual

The Sequencing Menu

Pressing the Lse(L) key accesses the Sequencing menu. This menu leads to a series of menus that
The ~.~~~~~~~~~~ softkey, located in the Sequencing menu, activates a feature that allows
::
the sequence to branch off to another sequence, then return to the original sequence. For
example, you could perform an amplifier measurement in the following manner:
1. Create sequence 1 for the specific purpose of performing the gain measurement and printing
the results. This sequence will act as a sub-routine.
2. Create sequence 2 to set up a series of different input power levels for the ampliiler gain
measurements In-between each power level setting, call sequence 1 as a sub-routine by
results for each input power level applied to the amplifier.
Right TTL compatible output lines can be used for controlling equipment connected to the
the individual output bits Refer to Figure 6-81 for output bus pin locations.
Five ITL compatible input lines can be used for decision making in test sequencing. For
example, if a test Mure is connected to the parallel port and has a micro switch that needs to
be activated in order to proceed with a measurement, you can construct your test sequence
so that it checks the 'ITL state of the input line corresponding to the switch. Depending on
whether the line is high or low, you can jump to another sequence. 'lb access these decision
Applicationmd Operation Concepts
by