Data Processing Flow Diagram - HP 8753E User Manual

AVERAG I NG
( O P T 0 1 0 )
S M O O T H I N G
Note
If the analyzer has an active two-port measurement calibration, all
four S-parameters will be saved with the measurement results All four
S-parameters may be viewed if the raw data array has been saved.
1. If you want to title the displayed measurement, refer to "Titling the Displayed
Measurement," located earlier in this chapter.
3.
Choose one of the following disk drives:
a. Connect an external disk drive to the analyzer's HP-IB connector, and coniigure as
follows:
. . . . . . . . . . . . / . . . . . . . . . . . . . i. i . . . . . . . . . . ~ . . . . . . . . . ~ . . . . . . . . . . . . ~ ; ; . . . . . . . . . _ ' ; , . . . . . . . . . , . . . . . . ; ; z . . . . . . . . . . . A . . . . . . . . A . . . i i / . . . . . . A . . . w .
followed by (XJ).
where you want to store the instrument state file.
e. Enter the HP-LB address of the peripheral, if the default address is incorrect
(default = 00). Follow the entry by pressing (xl).
D A T A
A R R A Y S
I I I
A R R A Y S
Figure 4-12. Data Processing Flow Diagram
D A T A
A R R A Y S
T R A N S F O R M
( O P T OIOJ
. . .
Printing, Plotting, and Saving Measursment Results
TRACE
M A T H
I