To Connect To A Controller - HP 1660CS-Series User Manual

To connect to a controller

You can control the HP 1660CS-series logic analyzer with another
instrument, such as a computer running a program with embedded analyzer
commands. The steps below outline the general procedure for connecting to
a controller using HP-IB or RS-232-C.
Turn off both instruments, and connect the cable.
1
If you are using RS-232-C, the cable must be a null-modem cable. If you do
not have a null-modem cable, you can purchase an adapter at any electronics
supply store.
Turn on the logic analyzer and then the controller.
2
In the System External I/O menu, select the field under Connected
3
To: in the Controller box and set it appropriately.
The figure below is for HP-IB.
Select the appropriate Settings field and configure the values in the
4
pop-up menu to be compatible with the controller.
See Also
HP 1660C/CS-Series Logic Analyzers Programmer's Guide and the LAN
User's Guide for more information on connecting controllers.
Connecting Peripherals
To connect to a controller
2-9