HP 8753E User Manual page 587

ANALOG BUS DISABLED IN 6KHZ IF BW
Error Number When you press~~~~'~~~~~~~~,,, the analogbusis disabled and not
212
available for use in troubleshooting. For a description of the analog bus, refer
HP 875333 Semvice Guide.
to the
ANOTHER SYSTEM CONTROLLER ON HP-IB BUS
Error Number You must remove the active controller from the bus or the controller must
relinquish the bus before the analyzer can assume the system controller mode.
37
ARGUMENT OUT OF RANGE
Error Number The argument for a programming command is out of the specified range. Refer
HP 8753E Programming and Command lilt.#r- tiide
206 to the
programming commands and argument ranges.
ASCII: MISSING 'BEGIN' STATEMENT
Error Number The CITIflle you just downloaded over the HP-IB or via disk was not properly
193 organized. The analyzer is unable to read the "BEGIN" statement.
ASCII: MISSING 'CITIFILE' STATEMENT
Error Number The CITIflle you just downloaded over the HP-IB or via disk was
194 organized. The analyzer is unable to read the "CITIFILE" statement.
ASCII: MISSING 'DATA' STATEMENT
Error Number The CITIflle you just downloaded over the HP-B3 or via disk was not properly
organized. The analyzer is unable to read the "DATA" statement.
195
for a list of
not
properly
Error Messages 1 O-3