Enable Web User Interface; Applying Licenses - Avaya 1000 Series Configuration Manual

Secure Router Basics

Enable Web User Interface

To enable the Web User Interface, use the following command:
SR/config> gui enable

Applying licenses

While the Secure Router can be purchased with up to 4 ports activated, the Secure Router
1002 and 1004 base models each ship with one active WAN port. Activating additional ports
requires only a simple change to the router configuration with a software key that may be
purchased to activate up to three additional WAN ports. This key is different than the software
upgrade key.
To obtain a port upgrade key, contact your reseller or Avaya. You will be asked to provide the
serial number, model number, and the number of ports that are currently active on your router.
The following procedure describes how to activate additional WAN ports in the SR1002 and
SR1004.
1. From the command line interface, issue the following command:
2. Issue the following command:
3. Enter the license key provided.
22 Avaya Secure Router 1000 Series Configuration Guide
Avaya>configure terminal
Avaya>system licenses < option >
The option parameters are:
• enable_1_port
• enable_2_ports
• enable_3_ports
• enable_4_ports
Note:
The total number of active ports is equal to the sum of existing active ports and
the type of license purchased (1, 2, or 3 port) to a maximum of 2 ports on the
Secure Router 1002 and 4 ports on the Secure Router 1004
You will be prompted for the port upgrade license key.
December 2010