Daylight Saving Time Support; Multiple Sntp Server Support - Avaya 1000 Series Configuration Manual

4. Reboot the router.

Daylight Saving Time support

Daylight Saving Time is now supported on the Secure Router for time zones for in US, Canada,
and Australia.
To enable Daylight Saving Time, use the following procedure.
1. To enter the configuration mode, enter:
2. To enable daylight saving time, enter:
3. To display the daylight savings time configuration, enter:

Multiple SNTP Server support

The Secure Router 1000 Series and 3120 provide support for the Multiple Simple Network
Time Protocol (SNTP) Server feature. SNTP is a simple form of the Network Time Protocol
(NTP), which is an internet protocol used for synchronization of computer clocks.
The Multiple SNTP Server feature provides support for up to 10 SNTP servers. Multiple servers
provide redundant backup for synchronizing time on the Secure Router. During configuration,
servers can be specified by hostname or IP address, and a timeout value must be set for the
query. The Multiple SNTP Server features operates by having the SNTP service query
configured SNTP servers on a round robin basis. If any SNTP server is queried and fails to
respond, the router will send a request to the next configured SNTP server. The sntp server
support is not active until the service is enabled. While the service is enabled the configuration
can not be changed.
The show sntp command has been modified to display the current state of SNTP, the server it
is contacting to receive the current time, as well as all configured servers. When specifying a
Avaya Secure Router 1000 Series Configuration Guide
The license key is case sensitive.
Note:
It is important that you do not enter any extra spaces at the end of the license
key, as this may produce an error.
configure terminal
dst enable
show dst
Daylight Saving Time support
December 2010 23