Avaya 1000 Series Configuration Manual page 274

Backup Interface-ISDN
1. Configure the ISDN switch type.
2. Save the configuration and reboot the router.
3. Verify that the switch type is correct:
4. Configure a WAN bundle (refer to the illustration above).
5. Configure ISDN.
6. Verify the ISDN interfaces.
274 Avaya Secure Router 1000 Series Configuration Guide
Router1/configure> isdn switch-type basic-ni
ISDN Switch type changed. Please reboot the box
for this change to take effect.
Router1/configure> exit
Router1> save local
Router1> show isdn global ISDN Global Configuration
-------------------------
Switch Type: basic-ni Interface Type: U Interface
Router1/configure> interface bundle wan1
Configuring new bundle
Router1/configure/interface/bundle wan1> link bri
128
Router1/configure/interface/bundle wan1> encapsulation
ppp Router1/configure/interface/bundle
wan1> ip address 2.2.2.1 24
Router1/configure/interface/bundle wan1> isdn
Router1/configure/interface/bundle wan1/isdn>
callednum 384010
Router1/configure/interface/bundle wan1/isdn>
idle-timeout 5
Router1/configure/interface/bundle wan1/isdn>
connect-delay 10
Router1/configure/interface/bundle wan1/isdn>
spid1 3840200001
Router1/configure/interface/bundle wan1/isdn> tei
p
Please save and reboot the box for this change to
take effect
Router1/configure/interface/bundle wan1/isdn> exit
4
Router1> reboot
Note:
Spid configuration is optional for most switch types, but not for basic ni.
Router1> show isdn interfaces ISDN Information:
wan1
--------------------------
caller -
answer1 -
answer2 -
called-number 384010
spid1 3840200001
spid2 -
idle-timeout 5 minutes
connect-delay 10 seconds
keep-alive 10000 ms
disconnect-cause 17
December 2010